Information :

Using un-saturable polyester resin as basic material and unidirectional fiberglass woven fabrics as skeleton, the FRP pole is taken shape by centrifugal process. It could be used as luminary pole, utility pole, flag pole and other applications and have distinctive advantages compared with the traditional material ones, such as steel pole, aluminum pole, concrete pole and wood pole.

Features:
Corrosion resistant, High strength, Non-conductive, Low maintenance & anti-ageing, Aesthetics, smooth and beautiful appearance, light weight and ease of assembly

Specification:
FRP Lighting pole divides into direct- burial pole and anchor-base pole, the direct-burial pole includes: shaft, single arm, double arm. Anchor-base pole include: FRP base shaft, FRP base single arm, FRP base double arm, steel base shaft, steel base single arm and steel base double arm.
Our company has two tapers for the lighting pole, one type is 1/75, the minimum diameter is 80mm, the maximum diameter is 260mm and the maximum length: 12000mm; the other type is 1/55, the minimum diameter is 80mm, the maximum diameter is 298mm and the maximum length is12000mm.

FRP base specification:

Steel base specification:

Shaft	Wire hole	FRP anchor base flange
Double arm	?Wire hole cover	Steel base

Standard
Our company designs and produces the FRP lighting pole according to ANSI CI 136.20:1990 <<Fiberglass Reinforcement Plastic Lighting Pole>>
The exterior surface should be smooth and aesthetic, shall be free of crack, air bubbles, damage or any exposed surface fiber.
The surface of the pole should be finished with an ultraviolet-resistant uniform coating and has exceptional weather-resistance performance.
The interior surface should be free of stratification, blocking and white stain that is the result of the fiber not being thoroughly wetted by the resin.
>The cover of wire hole must be waterproof, the metal fittings to be used for interior fastening must be hot galvanized or stainless steel.
The height of the FRP Lighting Pole should have a tolerance of +30mm, -0mm and the thickness is +3mm, -0mm.
The surface hardness of the pole should be over 35.
The bent strength of the pole should be over 320Mpa.
According to AASHTO.LTS.2:198, the pole shall not exceed a maximum deflection of 10% of the pole length above the ground line when subject to the maximum simulated wind loading and shall not have more than 1% permanent deflection.

Application

Public square, park, street, capital airport, courtyard, highway, factory, bridge, packing lots

Capital airport	Highway	Public square	Factory
courtyard	Bridge	street	Packing lots

Installation:

Three people can install,need no machine to operate	Check whether the pole is at a right angle to the earth’s surface by plumb line	Place the pads on the bolt and tighten it with spanner

Other data
The supplier should provide the following information to the manufacturer:
Height, supporting length, weight, effective projected area of the pole,
Weight and EPA of the luminaries,
Weight, height, EPA of other possible attachment,
Color and paint requirement of pole,
Maximum steady wind velocity at location,
Other performance requirement.